Why Is My Pool Light Dim?

A backyard pool can provide years of enjoyment for the entire family. Gatherings are more enjoyable when there's a pool. The warm Tampa, as well as St. Petersburg, evenings provide an excellent occasion for adults to relax at the pool's patio and enjoy an after-dinner dip. There's nothing more appealing than a sparkling swimming pool waiting to be enjoyed by you and your loved ones.

One of the most effective ways to make your pool more attractive when the sun goes down is to install lighting. Lights for your pool will illuminate the sparkling waters and create a secure night-time swimming space. They offer security, particularly when kids are in the vicinity. However, if your lights start acting up, dimming, or switching off and on or turning off without reason, you must determine the cause of the problem in the pool lighting and do it fast.

Reasons For Dimming Pool Lights



There are many parts that are involved in lighting your pool. It is not always the case that all solutions are easy. If electricity is required, it is best to employ a licensed electrician. Electrical work isn't an easy task to do yourself, particularly when it involves water. It is best to leave repairs to experts.

Knowing the causes of the intermittent or dimming lighting in your pool can assist you in understanding the task that needs to be completed. It could be a simple fix, like fixing loose housings or bulbs, or something more complicated that will require expert electrical work. Here are some typical causes of dim or defective lights for the pool.

• Loose-fitting. A common reason for lighting that dims is due to the housing being shaky. A variety of activities in the pool, such as kids playing, who jump in and out of the pool, or similar, could cause the locks screws to loosen. Sometimes, it's as simple as getting into the pool using your Philips screwdriver and tightening the screw that locks the pool. If your screw is damaged in any way, don't replace it. There's an O-ring that is in the same place, which acts as a gasket, creating an impervious seal. It should be replaced in conjunction with the screw.

• Leaky housing. Your light is housed in a lens and gasket for the housing that keeps its waterproof seal. As time passes, the hard rubber gasket may disintegrate. Exposure to chlorine and other chemicals in the pool can degrade the seal. Water can get into the housing, causing the light to go out. If water is able to enter the housing, the breaker or GFCI might trip. If it appears that more than the gasket itself is damaged, the best step is to contact the electrician.

• Burnt-out bulb. It may appear like a simple fix—just replace the bulb that is burned out, you think? But, it's not that simple! If your bulb is new and completely gone out of the market (broken filament is obvious), you must consult an electrician. Bulbs that are burning out before their time could signal an electrical problem that could be caused by an over-voltage or damaged wiring.

• Overloaded circuit breaker. An overloading circuit breaker could stop the flow of electricity to the circuit once it is extremely overloaded. If you think the issue is with your breaker because of continuous "tripping," you will have to call a licensed electrician. The breaker is also connected to the wiring in your home. It shouldn't be fixed or replaced by any other person than a certified professional.

• Shock hazard/GFCI. When the pool wiring was put in place, it was equipped with a Ground Fault Circuit Interrupter. This device is put in place in the event of an increased chance of experiencing a shock. If the GFCI detects an occurrence of shock, it will stop the current at the line. Then, call an expert.

• Continuity disruption. Whether from damage to cables, surges of power, or any other issue in the flow of power, the light in your pool could be affected. This isn't a DIY solution. Finding the cause of the disruption within your electrical line can be challenging, at the very least, for an electrician with no license.